Полигон призраков

Код: Выделить всё

​IMPORTANT NOTE: These are "real mode" programs, to be run from Autoexec.bat.
                They will not run if you have "device=emm386.exe" in Config.sys.

Files    : k6waon.exe,    4,272 bytes (7-21-2000)
         : k6waonh.exe,   4,480 bytes (9-02-2000)

Author   : Uart

Function : Turns Write allocation On for k6-2(cxt), k6-3, k6-2+, k6-3+
           k6waon does NOT leave a "hole" in the address space at 15..16M.
           k6waonh leaves a hole in the 15-16M region and is only needed
           if you have some IO device that maps to this region.
           MOST PEOPLE DO NOT NEED TO USE k6waonh and should just use k6waon.

Usage    : k6waon(h) <mem_size_in_MB>

Examples : k6waon 128   ; Turns on W/A for 128MB of memory (no 15..16M hole).
         : k6waon 0     ; Disables W/A
         : k6waonh 64   ; Turns on W/A for 64MB memory (with hole at 15..16M).
         : k6waonh 0    ; Disables W/A


Notes:

    - Must be run from DOS or from Autoexec.bat in the case of win95/98/98SE

    - This version is very basic. It doesn't identify the processor and it
      is therefore the users responsibility to check they have the correct
      cpu type. The target cpu's are,
      k6-3   All versions,
      k6-2+  All versions,
      k6-3+  All versions,
      k6-2   cxt versions. 

      If you have a standard k6-2 (not a k6-2+) and are unsure as to
      whether or not it is a cxt version then read the following.
      All k6-2's rated at 400MHz or faster are cxt types. Many 300MHz
      to 380MHz chips are also cxt. If the stepping is 8 or higher
      then your k6-2 is a cxt type. (NB: Some cpuid programs report
     steppings 10..15 as 'A'..'F' respectively).


    - This program was written because the commonly used setk6 utility
      currently doesn't work with k6-2+ and k6-3+ processors.